Honda HRD536C, Руководство пользователя

Страница: 13 / 88

13 EN
USING THE LAWNMOWER AFTER A STORAGE
PERIOD
1. Remove the spark plug, check that it is clean and that the
electrode gap is correct ( see page 8 ). Pull the starter several
times.
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight; then use a plug spanner to
tighten it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil ( see page 5 ).
4. Fill the fuel tank and start the engine.
NOTE : If the cylinder has been coated with oil, the engine will
smoke on start-up. This is normal.
TRANSPORT
Do not tilt the lawnmower since this may cause fuel or oil
spillage; spilt fuel or even fuel vapours are a fire hazard.
TRANSPORTING THE LAWNMOWER
1. Place the throttle control
lever in “STOP” position and
remove the switch key for
models where fitted.
2. Pull off the spark plug cap.
3. Close the fuel shut-off valve
[1]. To facilitate the
operation, remove the grass
catcher (
see page 4 ).
NOTE : When folding the
handle, check that the cables
are not knotted, twisted or too
tight.
4. Unscrew the knobs [2], fold
the handle support [4] and
the handle [3]. Re-screw the
two knobs on the handle to
avoid to loose them.
LOADING THE LAWNMOWER
CAUTION:
• To prevent losing control of or damaging the lawnmower, do not
use the drive system when going up or down a loading ramp.
• To prevent damaging the drive system, do not engage the clutch
when the lawnmower is rolling backwards.
• Transport the lawnmower in normal horizontal position with its
four wheels flat on the vehicle platform.
• We recommend that you use a loading ramp or that you get
someone to help you load and unload the lawnmower.
• Adjust the loading ramp so that it is inclined at an angle of less
than 15°.
• When transporting the lawnmower, immobilise it using straps and
place chocks under the wheels.
• The straps must not touch the following parts of the lawnmower:
throttle control lever, cutting-means control lever, fuel tank and all
the control cables.
USEFUL INFORMATION
FIND AN APPROVED DEALER
Please refer to the European Internet site:
http://www.honda-eu.com
CURRENT PARTS, OPTIONAL ATTACHMENT AND
CONSUMABLES
To buy one of the original parts listed below, or any other part,
please contact an approved Honda reseller.
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your lawnmowers' model and type.
SAFETY
C18 C11
[1]
[2]
[2]
[3]
[4]
[4]
HRD536C
Current parts
[5] Grass catcher 81320-VF1-D51
Grass catcher only
(without frame)
[6] Rear wheel 42710-VF1-000
[7] Air filter 17211-Z8B-901 Filter paper
[8] Front wheel 44710-VF0-000
[9] Spark plug 98079-55846 NGK: BPR5ES
[10]
Standard
cutting means
72511-VG0-C50
Requires use of a
dynamometric key
[11]
Recoil
starter
28462-ZL8-V71
Ask your Honda dealer
to replace these
Optional part
[12] Mulching kit 06762-VF1-C51
1 upper cutting means,
1 mulching plug,
1 Owner’s Manual
Consumables
[13] Engine oil
08221-888-061HE
SAE 10W30, 0.6

Oil for 4-stroke engines
[5] [7] [6] [8]
[9]
[12] [10] [13] [11]
SAFETY
D3 C23
A2 C5
3RVF06210.book Page 13 Tuesday, November 13, 2018 3:06 PM