If the fluid level is at or below the MIN mark, have a dealer inspect for leaks or
worn brake pads as soon as possible.
Brake fluid marked DOT 5 is not compatible with your vehicle’s braking system
and can cause extensive damage.
Changing Wiper Blades
If the wiper blades leave streaks across the windshield, try cleaning them first
with a paper towel or soft cloth and wiper fluid. If the wiper blade rubber has
deteriorated, you should change the wiper blades.
1. Set the power mode to VEHICLE OFF (LOCK).
2. Lift the driver side wiper arm first, then the passenger side.
3. Press up on and hold the tab, then slide the holder off the wiper arm.
4. Pull the end of the wiper blade in the direction of the arrow in the image until
it unfastens from the holder's end cap. Pull the wiper blade to the opposite
direction to slide it out from its holder.
5. Insert the flat side of the new wiper blade onto the bottom part of the holder.
Insert the blade all the way.
6. Install the end of the wiper blade into the end cap.
7. Slide the wiper holder onto the wiper arm securely.
8. Lower the passenger side wiper arm first, then the driver side.
Avoid dropping the wiper arm, as it may damage the windshield.
Tire Information
To safely operate your vehicle, your tires must be of the proper type and size, in
good condition with adequate tread, and properly inflated.
n
Inflation Guidelines
• Properly inflated tires provide the best combination of handling, tread life,
and comfort. Refer to the driver’s doorjamb label or see SPECIFICATIONS
for the specified pressure.
• Underinflated tires wear unevenly, adversely affect handling and fuel
economy, and are more likely to fail from overheating.
• Overinflated tires make your vehicle ride harshly, are more prone to road
hazards, and wear unevenly.
• Every day before you drive, look at each of the tires. If one looks lower
than the others, check the pressure with a tire gauge.
MAINTENANCE
134 |
• Measure the air pressure when tires are cold. This means the vehicle has
been parked for at least 3 hours, or driven less than 1 mile (1.6 km). If
necessary, add or release air until the specified pressure is reached. If
checked when hot, tire pressure can be as much as 4-6 psi (30-40 kPa,
0.3-0.4 kgf/cm
2
) higher than checked when cold.
• At least once a month or before long trips, use a gauge to measure the
pressure in all tires, including the spare. Even tires in good condition can
lose 1-2 psi (10-20 kPa, 0.1-0.2 kgf/cm
2
) per month.
U.S. Models
Whenever tire pressure is adjusted, you must calibrate the TPMS.
n
Inspection Guidelines
Every time you inflate the tires, check for the following:
• Any damage to tires, including bumps, bulges, cuts, splits, or cracks in
the side or tread. Remove any foreign objects and inspect for air leaks.
Replace tires if you see fabric or cord.
• Uneven or excessive tread wear. Have a dealer check the wheel
alignment.
• Cracks or other damage around the valve stems.
n
Wear Indicators
The groove where the wear indicator is
located is 1/16 inch (1.6 mm) shallower
than elsewhere on the tire. If the tread
has worn so low that the indicator is
exposed, replace the tire. Worn out
tires have poor traction on wet roads.
Using tires that are excessively worn or improperly inflated can cause a
crash in which you can be seriously hurt or killed. Follow all instructions in
the owner’s manual regarding tire inflation and maintenance.
Example of a wear
indicator mark
MAINTENANCE
| 135
