Honda EM10000K1, Руководство пользователя

Страница: 33 / 59

8-9
dummyhead dummyhead
GENERATOR/CHARGING SYSTEM
REAR HOUSING/STATOR
REMOVAL/INSTALLATION
• Take care not to damage the stator coil and rotor coil
when removing/installing them.
• Do not strike any part of the rotor when removing it.
The rotor may be damaged.
• Place the stator core side down. Do not set the
stator on the coil end. The coils may be damaged.
• If for some reason it is necessary to place the stator
with the coil side down, be sure to lay it gently on top
of cloth or other similar padding.
• Always remove the brush holder before removing
the rear housing. If the rear housing is removed with
the brush holder attached, damage to the brush
holder will occur.
Remove the generator end cover (Base shop manual:
page 5-2).
Open the harness band (1).
Disconnect the connector (2).
Remove the following:
SH, SKH type:
– tapping screw (5 x 14 mm) (3)/cable tie (4)
– two washer-screws (4 x 8 mm) (5)/field winding
terminals (6)
– washer-screw (6 x 12 mm) (7)/ground terminal (8)
– two screws (6 x 8 mm) (9)/spring washers (10)/main
winding terminals (11)
– two screws (6 x 8 mm) (12)/spring washers (13)/
main winding terminals (14)
LDH type:
– tapping screw (5 x 14 mm) (3)/cable tie (4)
– two washer-screws (4 x 8 mm) (5)/field winding
terminals (6)
– washer-screw (6 x 12 mm) (7)/ground terminal (8)
– three screws (6 x 8 mm) (9)/spring washers (10)/
main winding terminals (11)
– three screws (6 x 8 mm) (12)/spring washers (13)/
main winding terminals (14)
(4)
(1)
(2)
(3)
(5)
(6)
(9)
(10) (11)
(14)
(13)
(12)
(7)
(8)
(4)
(1)
(2)
(3)
(5)
(6)
(9)
(10)
(11)
(14)
(13)
(12)
(7)
(8)
SH, SKH type:
LDH type: