Honda CRF450X 2020, Руководство пользователя и соревновательное пособие

Страница: 107 / 204

Suspension
(cont’d)
Servicing Your Honda
99
Suspension
Refer to Important Safety Precautions on page 31.
Loose, worn, or damaged suspension components
may adversely affect the handling and stability of
your CRF. If any suspension components appear
worn or damaged, see your dealer for further
inspection. Your dealer is qualified to determine
whether or not replacement parts or repairs are
needed.
• When your CRF is new, break it in for
approximately 1 hour to ensure that the
suspension has worked in (page 27).
• After break-in, test run your CRF with the
front suspension at the standard setting before
attempting any adjustments.
• For optimum fork performance, we
recommend that you disassemble and clean the
fork after riding your CRF for 3 hours.
See page 100 for front suspension removal.
• Replace the fork oil every 6 races or 22.5 hours
of running. See page 103 for oil capacity
adjustment after changing the fork oil.
• Replace the damper oil every 6 races or 22.5
hours of running. See page 109 for damper
fork oil replacement.
• Use Pro Honda HP Fork Oil, SS-19 or an
equivalent which contains special additives to
assure maximum performance of your CRF’s
front suspension.
Periodically check and clean all front
suspension parts to assure top performance.
Check the dust seals for dust, dirt, and foreign
materials. Check the oil for any contamination.
• Refer to Suspension Adjustment Guidelines
(page 149). Make all rebound and compression
damping adjustments in one-click increments.
(Adjusting two or more clicks at a time may
cause you to pass over the best adjustment.)
Test ride after each adjustment.
• If you become confused about adjustment
settings, return to the standard position and
start over.
• If the fork is still too stiff/soft after adjusting
compression damping, determine which
portion of the travel is still too stiff/soft. This is
an important step that will help you solve
suspension problems.
1. Make sure that the fork protectors (1) and dust
seals (2) are clean and not packed with mud
and dirt.
2. Check for signs of oil leakage. Damaged or
leaking fork seals should be replaced before
your CRF is ridden.
3. Inspect the wear rings (3) for wear or damage.
Replace the wear ring if it is 0.06 in (1.5 mm)
or flush with the outer tube (4). Remove the
fork leg when replacing the wear ring.
Install the wear ring with its end gap (5) facing
rearward.
Front Suspension Inspection
(1) fork protectors (2) dust seals
(1)
(2)
(3) wear rings (4) outer tube
(3) wear rings (5) end gaps
0.06 in (1.5 mm)
(4)
(3) (3)
(5)
(3)
31MKE710.book 99 ページ ２０１９年３月１１日 月曜日 午前１０時４７分