Honda CBR125R, Руководство пользователя

Страница: 72 / 430

MAINTENANCE
3-16
Inspect the water hoses for cracks or deterioration,
and replace them if necessary.
Check the tightness of all water hose band screws
(page 6-14).
DRIVE CHAIN
DRIVE CHAIN SLACK INSPECTION
Never inspect and
adjust the drive
chain while the
engine is running.
Turn the ignition switch OFF, support the motorcy-
cle on its sidestand and shift the transmission into
neutral.
Check the slack in the drive chain lower run midway
between the sprockets.
Excessive chain slack, 50 mm (2.0 in) or more, may
damage the frame.
ADJUSTMENT
Loosen the axle nut.
Loosen the lock nuts and turn the adjusting nuts
until the correct drive chain slack is obtained.
Make sure the index lines on both adjusting plates
are aligned with the rear end of the axle slots in the
swingarm.
Tighten the axle nut to the specified torque.
Hold the adjusting nuts and tighten the lock nuts.
Recheck the drive chain slack and free wheel rota-
tion.
Check the drive chain wear indicator label attached
on the left swingarm.
If the drive chain adjusting plate arrow mark
reaches red zone of the indicator label, replace the
drive chain with a new one (page 3-18).
WATER HOSES
DRIVE CHAIN SLACK: 25 – 35 mm (1.0 – 1.4 in)
25 – 35 mm (1.0 – 1.4 in)
TORQUE: 59 N·m (6.0 kgf·m, 44 lbf·ft)
AXLE NUT
ADJUSTING NUT INDEX LINES
LOCK NUT SLOT
RED ZONE ARROW MARK