Honda 2006 CR-V, Руководство пользователя, Страница: 167 / 274

−
−
Turning the ignition switch to the
LOCK (0) position turns this mode
off. When you restart the engine,
select the D position and press the
D3 mode switch again to use this
mode.
Shifting out from the D position will
cancel the D3 mode, and the D3
indicator will go out. Selecting the
D3 position again will resume the D3
mode and the indicator comes on.
The D3 mode indicator also comes
on for a few seconds when you turn
the ignition switch to the ON (II)
position.
To shift to second,
pull the shift lever towards you, then
shift to the lower gear. This position
locks the transmission in second
gear. It does not downshift to first
gear when you come to a stop.
If you shift into first position when
the vehicle speed is above 31 mph
(50 km/h), the transmission shifts
into second gear first to avoid
sudden engine braking.
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
rpm below the red zone.
Use second gear:
For more power when climbing.
To increase engine braking when
going down steep hills.
For starting out on a slippery
surface or in deep snow.
To help reduce wheel spin.
When driving downhill with a
trailer.
To shift from second to
first, pull the shift lever towards you,
then shift to the lower gear. This
position locks the transmission in
first gear. By upshifting and
downshifting through 1, 2, and D,
you can operate the transmission
much like a manual transmission
without a clutch pedal.
Automatic Transmission
Second (2)
Engine Speed Limiter
First (1)
164