Issue Date
INSTALLATION
INSTRUCTIONS
Accessory
Application
Publication No.
Honda Dealer: Please give a copy of these instructions to your customer.
© 2012 Honda Motor Co., Ltd. - All Rights Reserved.
PARTS LIST
87963-MGS-A500
1 of 2
SADDLEBAG PANEL
P/N 08F73-MGS-A50
COMMON
Mll 13973
May 2012
No.
Description
Qty
(1(
Right saddlebag panel
1
(2(
Left saddlebag panel
1
(3(
Left emblem
1
(((
Right emblem
1
(5(
Push rivet
2
TOOLS AND SUPPLIES REQUIRED
Electric drill
Drill bit (( mm(
Plastic hammer
Drift (O.D. approx. 5 mm(
Isopropyl alcohol
Shop towel
(1(
(2(
(3(
(5(
(((
ELECtRIC DRILL
(( mm bIt(
RIGHt SADDLEbAG LID
INSTALLATION
NOtE:
Heat the bonding surfaces with a hair dryer if the
•
ambient air temperature is below 70°F (21°C(.
the adhesive reaches full strength in 72 hours. Wait
•
at least 2( hours before riding your motorcycle.
1. Drill the right saddlebag lid in the position shown.
Before performing this step, remove the
•
emblem from the right saddlebag.
Remove any burrs from the edge of the hole.
•
USE AND CARE INFORMATION
Check the accessory mounts frequently.
•
When this accessory becomes dirty, rinse it
•
thoroughly with cool water to remove loose dirt, then
wipe with a clean cloth or sponge. Do not use a
brush to clean this accessory as it may scratch the
surface.
Never use petroleum solvents such as gasoline,
•
thinner, or benzine to clean this accessory. Also do
not use acid or alkaline cleaners.
Wipe up spilled brake or battery fluid at once as they
•
may damage the plastic surface.
2. Peel back an end of the adhesive backings on the
back of the right saddlebag panel as shown.
ADHESIVE bACKINGS
Peel back leaving a little adhered.
ADHESIVE bACKINGS
Peel back leaving a little adhered.
ADHESIVE bACKING
Peel back leaving a
little adhered.
RIGHt SADDLEbAG PANEL
