HONDA marine BF115J, Руководство пользователя

Страница: 139 / 170

138
MAINTENANCE
If the fuse is blown, check the
cause, then replace the fuse with a
spare fuse of the same rated
capacity. Unless the cause is found,
the fuse may blow again.
Main Fuse
<Replacement>
A spare fuse is located on the reverse
side of the junction box lid.
1. Stop the engine.
2. Remove the engine cover.
3. Remove the junction box lid and
pull the old fuse out of the clip with
the fuse puller supplied in the fuse
holder.
4. Push a new fuse into the clips.
5. Reinstall the junction box lid, and
the engine cover.
6. Reconnect the battery.
DESIGNATED FUSE:
7.5 A, 10 A, 15 A, 30 A
Mechanical wire type
DBW type
Fuse No. Rating Component(s) or Circuit(s) Protected
1 100 A ACG, Battery
4 30 A STARTER SOLENOID, AND RELAYS IN JUNCTION BOX
5 10 A Power tilt relay, Warning buzzer, Indicator, Meter
8 10 A Fuel pump (High pressure side)
9 15 A Injector, ECU
10 10 A DLC, Fuel pump (Low pressure side)
11 15 A PTC
3 A Battery switch OFF notification
Fuse No. Rating Component(s) or Circuit(s) Protected
1 100 A ACG, Battery
2 15 A GROUND
3 7.5 A 12 V Accessory
4 30 A STARTER SOLENOID, AND RELAYS IN JUNCTION BOX
5 7.5 A REMOTE CONTROL SYSTEM
6 30 A SHIFT ACTUATOR
7 15 A THROTTLE BODY
8 10 A Fuel pump (High pressure side)
9 15 A Injector, ECU
10 10 A DLC, Fuel pump (Low pressure side)
11 15 A PTC
3 A Battery switch OFF notification
32ZVT600.book 138 ページ ２０２１年１０月１５日 金曜日 午後４時９分