Homewardbath STEAM PLANET Galaxy Series, Руководство по установке и эксплуатации, Страница: 8 / 17

6 | P a g e
INSTALL THE GASKETS
1. Once all is connected, place the wooden shower grid
floors and benches inside the unit.
2. Please, do not use the unit for at least 24hours or until
the silicone is completely dried.
HANDLE ASSEMBLY
TRIM FLANGE ATTACHMENT
1. Position trim (A) on the valve (B) with drain hole (C) at the
bottom.
2. Place protective washer (D) on the short end of the
reversible retainer sleeve (E).
3. Screw retainer sleeve (E) onto threaded section of the
stem and bonnet (G).
4. Tighten retainer sleeve (E) by hand until flange (A) is
snug to finished wall surface.
5. If the short end of the retainer sleeve (E) is too short,
reverse it to use the longer end.
HANDLE ATTACHMENT
1. Screw stem extender (A) onto the valve stem (B).
2. Thread the set screw (C) into the handle and thread it, in
only three or four turns.
3. With valve in CLOSED position, place handle (D) onto the
steam extender (A) and tighten the set screw (C) by using
the hex wrench (E) that is provided.
Make sure set screw (C) is tightened to the handle (D).