Homewardbath STEAM PLANET Galaxy Series, Руководство по установке и эксплуатации, Страница: 6 / 17

4 | P a g e
INSTALLATION INSTRUCTIONS FOR WS112 ALL SIZES
1. The distance between Wall A and Wall B should be at
least 1510mm (59.5 inches).
2. The minimum height for the unit (not including any base)
is 84.5 inches.
1510mm to 1530mm = 59.5” to 60.3”
DOOR FRAME ASSEMBLY
Note: For California only: Attach the door frame brackets
with self-tapping screws and expanding bolts.
1. Bottom horizontal rail has wide opaque gasket, top
horizontal rail has grey gasket.
2. The 5inch side panel trim piece has to be removed to
expose assembly screw holes.
3. Check to make sure the screw holes are tapped, on the
top and bottom horizontal rails.
Note: if they are not tapped, tap before assembling
4. To assemble front frame, you will need at least 6” #2
Philips bit. It is advised to use an impact driver. Do not
over tighten.
5. Each 5” frame sidepiece has 2 grey rubber gaskets on
top and bottom. Bottom piece has to be all the way down,
top piece – all the way to the top.
6. Assemble horizontal rails to wide vertical rails with
ST4X50 self-tapping screws.
INSTALLING SHOWER WALLS
Note: It is advised to assemble to soap dish with M4X25
screws (2 screws, 2 nuts, 2 bolts, 2 brass washers, and 2
caps) before putting any panels together. Also attach the
sliding bar for the handheld shower on the left side. Hardware
is inside cloth bag.
1.
Place large back panel on back side of base.
2. Remove trim piece from right side of left side glass panel.
This will expose the assembly screw holes.
3. Attach power supply and water supply to the left side
panel.
4. Attach left side panel to back panel using ST4X16 self-
tapping screws (pre-drilled holes should line up)
5. Attach right side panel in same fashion as previous step.
6. Attach the front glass frame that was assembled before,
using the ST4X16 self-tapping screws.
7. Run the drain hose from the steam box, through the small
hole on the bottom center of the left side panel. Hose
should extend into shower room. (Will be covered by floor
grids).
8. Seal unit to the acrylic base along the walls leaving the
corners open.
9. Attach all sides with tapping screws and blocks
10. Apply silicone to seal the gap between panels and floor.
Leave the corners without silicone.