HomeMatic IP Wall Thermostat - basic HmIP-WTH-B, Инструкция по монтажу и руководство по эксплуатации

Страница: 60 / 79

60
Start-up
Make sure that no electricity or similar lines run in
the wall at this location!
• Position the mounting plate on the desired site
on the wall. Make sure that the arrows on the
back side of the mounting plate point upwards
(see figure 10) .
• Use a pen to mark the positions of the two bore
holes according to the mounting plate with a
distance of 60 mm on the wall
(see figure 10) .
• Drill the marked holes (see figure 11) .
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.
• Use the supplied screws and plugs to fasten the
mounting plate to the wall (see figure 11) .
• Insert the electronic unit (A) into the mounting
plate (see figure 12) . Make sure that the electronic
unit properly engages into the mounting plate.
5.2.3 Installation on flush-mounted boxes
You can mount the wall thermostat on flush-mounting/
installation boxes using the screw holes
(see figure 13) .