HomeMatic HmIPW-WTH, Инструкция по установке и эксплуатации

Страница: 72 / 80

72
Operating modes and configuration
6.7 Offset temperature
As the temperature is measured on the wall thermostat,
the temperature distribution can vary throughout a room.
To adjust this, a temperature offset of ±3.5 °C can be set.
If a nominal temperature of e.g. 20 °C is set but the room
presents with only 18 °C, an offset of -2.0 °C needs to
be set. An offset temperature of 0.0° is set in the factory
settings. To adjust the offset temperature, please proceed
as follows:
• Select the symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.
• Turn the control wheel until the desired tempera-
ture appears (±3.5 °C maximum).
• Confirm by pressing the control wheel briefly.
6.8 Selecting the desired temperature display
You can adjust the temperature to be displayed. You can
also define whether the humidity value shall be displayed
or not.
• Select the symbol by turning the control
wheel and confirm by pressing the control wheel
briefly.
• Turn the control wheel and select
- “ACT” to display the actual temperature,
- “SEt” to display the setpoint temperature,
- “ACtH” for alternating between the actual
temperature and humidity display and con-