55
9 Resetting to factory status
To restore the factory settings of the Shutter Contact,
please proceed as follows:
•
Hold the teach button down for at least 5 se-
conds. The sensor LED starts to flash slowly in
red. (If you want to abort the reset procedure at
this time, you can press the teach button briefly
again or wait 15 seconds. In either case, the
flashing red will stop.)
•
To reset the sensor, press the teach button again
for at least 5 seconds. The LED starts to flash in
red faster while the button is held down.
•
Releasing the button completes the reset
procedure. The LED is illuminated for approx. 3
seconds to confirm the reset operation.
Possible error messages:
This error can occur now if you have a center
and have taught the sensor for this center.
If the LED does not start flashing after holding the but
-
ton down for 5 seconds but is illuminated continuously,
the sensor cannot be reset! In this case, the encoding
is active using a system security key that differs from
Содержание HM-Sec-SC-2
Страница 59: ...59...
