53
Start-up
If you want to pair the floor heating actuator with a
Homematic IP Wall Thermostat, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the channel to which you would like to pair
a device by pressing the channel button
(D)
brief-
ly (
see figure 7
). Press once for channel 1, press
twice for channel 2, etc. The channel is question
is shown in the display
(B)
.
• Press and hold down the system button
(A)
for
4 seconds until the LED quickly starts flashing
orange (
see figure 6).
The pairing mode of the
selected channel remains activated for 3 minutes.
• Press and hold down the system button of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED
(A)
lights up green to indicate that pairing
has been successful. If pairing failed, the device LED
(A)
lights up red. Please try again.
6.4.2 Pairing with a Homematic IP Multi IO Box
If you want to pair the floor heating actuator with a
Homematic IP Multi IO Box, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Keep pressing the channel button
(D)
briefly un-
til all channels are shown in the display
(B)
(
see
Содержание HmIP-FALMOT-C12
Страница 3: ...1 A B G E D C F I H J 1 2 3 4 5 6 7 8 9 10 11 12 ...
Страница 4: ...2 3 120 mm K L N M ...
Страница 5: ...4 5 ...
Страница 6: ...6 7 Channeltaste drücken Selecttaste drücken press channel button press select button ...
