HomeGuardian 4902013, Инструкция по установке и эксплуатации

Страница: 6 / 22

6
SECTION 6 - HOUSE SECURITY CODE AND ZONE CODE SETTINGS
You can change the house security code on each sensor, panel and other modules of your
security system to avoid interference with other systems.
In most cases you will NOT need to change the factory settings of the house security code. If
the Panel and sensors activate intermittently or do not work at all, you may be able to solve
the problem by changing the house security codes on all system modules.
Step 1: There are 4 jumpers/dip-switches on each device. Remove the jumper compart ment
cover, then pull out the Jumper to change the house security code setting and make sure the
jumpers on the Panel and it sensors match exactly.
Jumpers for house • Panel
security code • Each sensor
Default house code: 1: ON, 2: ON, 3: ON, 4: ON
*Jumper: ON = Plugged, OFF = Pull Out
Dip-Switches for house • System Controller
security code Default house code: 1: ON, 2: ON, 3: ON, 4: ON
SECTION 7 - MAINTENANCE
The product may be cleaned with a soft damp cloth and then wiped dry. Do not use
abrasive, solvent based or aerosol cleaners as this may damage and/or discolour the product.
Do not allow water to enter or attempt to clean inside the unit.
SECTION 8 - BATTERIES
Do not allow batteries to corrode and leak as this may cause permanent damage to the
product. Take care to insert the batteries with the correct polarity as shown inside the battery
compartments. Do not mix new and old batteries or different types of batteries. Do not fit
rechargeable batteries. At the end of their useful life the batteries should be disposed of via a
suitable Recycling Centre. Do not dispose of with your normal household waste. DO NOT BURN.
ON
ON
ON
4
4
DIP
3
3
2
2
1
1