8
Assembly - Standard Ceiling Mount
Routing the wires
Preparation for standard mounting
□
Route the wires exiting at the top of the fan-motor
assembly (E) through the canopy ring (FF).
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
□
Route the wires exiting the top of the fan motor
assembly (E) through the downrod as shown.
2
1
□
Remove the canopy ring (FF) from the canopy (C) by turning
the ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (DD) located in the “L
shaped” slots.
□
Remove and save the two canopy screws (EE) in the round
holes. This will enable you to remove the mounting bracket
(A).
Assembling the fan
□
Loosen, but do not remove, the setscrew (GG) on the collar
(II) on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar
(II), and turning it clockwise until it is tight.
□
Re-tighten the setscrew (GG) on the collar (II) on top of the
fan motor assembly (E).
3
NOTE:
This fan is equipped with a safety tab (HH). Should
the setscrew (GG) ever become loose while the fan is
running in reverse, the safety tab (HH) will engage and
stop the fan from falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(GG) must be completely tightened.
E
C
D
B
FF
E
B
HH
GG
II
C
A
FF
EE
DD