Assembly — Hanging the Fan (continued)
12
6
Preparing the receiver and
remote control
M
N
LL
NOTE:
The frequencies on your receiver and remote control
have been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and remote
control are set to the same frequency. The dip switches on
the remote control are located inside the battery
compartment.
NOTE:
The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of the used battery properly and keep
the battery out of the reach of children.
Setting the Code on the Remote:
□
Remove the battery cover on the back of the remote
control (N) by pressing firmly on the arrow and
sliding the cover off.
□
Slide the code switches to your choice of either up or
down. The factory setting is up.
□
The switch marked O/D controls the dimming
function of the lights. If using non-dimmable bulbs,
use a ballpoint pen or small screwdriver to set the
switch to O to disable the dimming function. If using
dimmable bulbs, set the switch to D to enable the
dimming function.
□
Install two AAA batteries (LL) (included).
□
Replace the battery cover on the remote control (N).
Setting the Code on the Receiver:
□
Slide the code switches on the receiver (M) to the
same positions as set on the remote control (N).
G
M
A
