9
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Hanging the Fan (continued)
3
NOTE:
The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit are
set to the same frequency. The dip switches on the hand unit
are located inside the battery compartment.
NOTE:
The switch marked “O/D” controls the dimming
function of the lights. If using non-dimmable bulbs, use a
ballpoint pen or small screwdriver to set the switch to “O” to
disable the dimming function. If using dimmable bulbs, set
the switch to “D” to enable the dimming function. The remote
is preset at factory to the “O” position.
Setting the code on the remote
control and receiver
□
Remove the remote control (L) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or
down. The factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (K) to the same
position as set on the remote control (L).
NOTE:
The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
hand unit. Dispose of used battery properly and keep the
battery out of the reach of children.
4
Installing the receiver
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
□
Insert the narrow end of the receiver (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until
it rests on top of the ball/downrod assembly.
WARNING:
To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION:
If other fan wires are a different color, have this
unit installed by a licensed electrician.
CAUTION:
Do not install the receiver in a damp location or
immerse in water (For indoor use only). Do not pull on or cut
the receiver leads shorter. Do not drop or bump the unit.
□
Install two 1.5V AAA batteries (included).
□
Replace the battery cover on the remote control (L).
□
Insert the silicone rubber stopper (OO) into the hole on the
receiver (K) to cover the dip switches.
NOTE:
This fan includes non-dimming CFL bulbs. If you would
like to use dimming function, please install dimmable light
bulbs (60-watt maximum incandescent bulbs or dimmable
LED bulbs)
L
K
ZZ
1
2
3
4
ON
D
O
12
34
ON
DIP
1
2
3
4
ON
D
O
1 2
3 4
ON
OO
B
C
AAA
BBB
A
K
