Operation (continued)
1. Fan button.
- Press and release the button to turn the fan on or off.
□
When turned on, the fan will begin spinning using its last speed settings. The remote control’s LED bar will display the speed setting
for 5 seconds.
□
When turned off, the fan will stop spinning and the light from the remote control’s LED bar will quickly darken from top to bottom.
Off
Setting
1
Setting
2
Setting
3
Disable
Comfort
Breeze
TM
OPERATING YOUR FAN AND REMOTE CONTROL
2. Speed functions
+
button, increases the fan speed
□
Pressing and releasing the + button one time will increase the speed of the fan. Each setting increase will cause the LED bar to
illuminate slightly more, until the fan has reached the maximum speed setting, at that time the LED bar will be fully illuminated.
□
Pressing and holding the + button will increase the fan speed automatically through the speed settings and the increments will be
denoted on the LED bar. When the LED bar is fully illuminated, the fan has reached maximum speed setting.
□
Pressing the + button while in Comfort Breeze
TM
mode will automatically cancel the Comfort Breeze
TM
mode and resume normal fan
operation.
–
button, decreases fan speed
□
Pressing and releasing the - button one time will decrease the speed of the fan. Each setting decrease will cause the LED bar to dim
slightly more, until the fan has reached the minimum speed setting. At that time the LED bar will be approximately 25% illuminated.
□
Pressing and holding the - button will decrease the fan speed automatically through the speed settings and the reductions will be
denoted on the LED bar. When the LED bar is 25% illuminated, the fan has reached the minimum speed setting.
□
Pressing the - button while in Comfort Breeze
TM
mode will automatically cancel the Comfort Breeze
TM
mode and resume normal fan
operation.
3. Comfort Breeze
TM
There are three Comfort Breeze
TM
settings. Pressing the button will activate the Comfort Breeze
TM
mode and the LED bar will illuminate
slowly from bottom to top to display the current setting.
□
Setting 1: Alternates through speeds 1 – 3, the LED bar should fill approximately 33%.
□
Setting 2: Alternates through speeds 1 – 6, the LED bar should fill approximately 66%.
□
Setting 3: Alternates through speeds 1 – 9, the LED bar should be fully illuminated.
NOTE:
The fan will store the last used speed setting for the next time it is turned on.
NOTE:
You must turn the fan on prior to using the speed or time functions.
NOTE:
On each start up of your ceiling fan, the fan blades will oscillate back and forth. This is a NORMAL OPERATION for DC motor ceiling
fans as they go through a calibration cycle. The fan is NOT DEFECTIVE.
NOTE:
If you are using Comfort Breeze
TM
mode, pressing the button or the fan speed buttons will cancel Comfort Breeze
TM
mode and
resume normal fan operation.
17
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.