Holzmann SB 162VN, Руководство пользователя

Страница: 27 / 40

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 27
SB162VN
14 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
14.1 Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
 Do not attempt to drill material with the surface other than flat unless a
suitable support is available!
 Never switch the machine on while pressing the drill bit against the
material!
 Do not look directly into the laser beam. Never direct the laser beam at
people or objects other than the workpiece.
 Do not deliberately point the laser beam at people.
 Only point the laser beam at insensitive workpieces with a dull surface.
Wood or rough surfaces are ideal for this. Shiny, reflective surfaces are
not suitable for using a laser since the laser beam could be directed at
the user by the reflective surfaces.
 Always switch off the laser when you have finished work at the ON/OFF
switch for the laser light.
 Only switch on the laser beam if there is a workpiece on the mitre saw
bench
N O T I C E
 Before switching the machine on, make sure that the table-clamping
lever is firmly tightened
 Make sure that the bit is firmly clamped in the chuck
 Due to the height of its own weight is the fixation of the drill press to
the ground requirement for less-vibration work.
 Use a clip or clamping jaws to secure the piece to be drilled on the table
 Set the drill to speed answering a specific job
 Check the V-belts and tighten if necessary
 Overtightening the belts can cause the motor to bind and not start. It
can also damage motor bearings!
 In advanced wear of, replace V-belt
 V-belts and pulleys may not come into contact with grease, oil or other
lubricants

Loosen the V-belt for a long break
 After drilling guide the spindle back to the top position by hand.