ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
30
HBS400
2.
Lift the cast iron table into the mounting position with the
aid of a second person or a technical lifting device, thread
the work table (W) through the saw band and position the
fixing screw in the swivel device.
3.
Fasten the worktable (W) to the swivel device (I) using
the fastening screw (F) and nut.
4.
Insert the table inlay (5).
N O T I C E
Check that the table inlay is at the same height
as the machine table.
5.
Mount the rip fence guide (3) on the worktable using the
6 screws and reattach the pin (2).
6.
Assemble the rip-fence (1) and, if necessary, the mitre
gauge (4).
15.3
Electrical Connection
W A R N I N G
Dangerous electrical voltage! The machine may only be connected to the mains
supply and the associated checks carried out by a qualified electrician or under the
instruction and supervision of a qualified electrician!
N O T E
Immediately after making the electrical connection, check the running direction of the
band saw rollers. Observe the direction arrow on the machine. The running direction
is correct if the saw band runs from top to bottom. If this is not the case, swap two
phases, e.g: L1 and L2, on the mains plug.
The wood band saw is operated either with 230 V (models HBS500 or HBS610) or with 400 V
(only model HBS610). The electrical connection is made via a switch-plug combination. This
device must be operated via a residual current circuit breaker. The electrical connection for the
400 V band saw must be 5-pin (see below).