Holzmann D 460FXL, Руководство пользователя

Страница: 34 / 96

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 34
D 460FXL
15.3 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
NOTICE
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.4 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
16 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble Possible cause Solution
Machine does not start  Switch defective  Repair switch
 Power supply is off  Repair power supply
 Fuse is defective  Change fuse
 Circuit breaker is active  Push in the circuit button
Strong vibration  Warped workpiece  Change material
 Workpiece is wrong centered  Measure the center newly
 Loosen pulley  Tighten the pulley
 Outworn pulley  Change pulley
 Turning lathe is on uneven surface  Level the surface
 Loosen tail- or headstock  Tighten
 Too much speed  Adjust speed
Bad turning result  bad sharpened chisel  Sharpen the chisel
 Wrong chisel for this work  Select the right chisel
 Wrong adjustment of tool rest  Adjust the high and the
distance of the tool rest
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
NOTICE
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.