Holzmann D 460FXL, Руководство пользователя

Страница: 28 / 96

ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 28
D 460FXL
13.2.2 Face plate
Thread the faceplate (1) onto the end of the headstock spindle and
hand tighten. Place the wrench (2) over the flats on the faceplate.
Insert the tip of the push-out rod (3) into one of the slots in the side of
the headstock spindle. While gripping the push-out rod firmly, turn the
wrench to either tighten or loosen the faceplate. Remove the push-out
rod and wrench. If the faceplate is being removed, continue turning it
until it comes off the spindle threads.
WARNING
Do not operate the lathe until it is completely
assembled and adjusted according to the instructions.
13.2.3 Spur center
Insert the tailstock cup center (1) into the hollow center of the
headstock spindle.
Insert the shaft (1) of the tailstock center into the hollow center of the
tailstock spindle.
Insert the push-out rod (1) into the far end of the headstock spindle or
the tailstock spindle until it comes into contact with the shaft of the
spur or center. Tap the end of the push-out rod (1) until the spur or
center comes loose.