HOLZMANN MASCHINEN TS 250F, Руководство пользователя, Страница: 47 / 170

ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 47
TS 250F
12.2.2 Assembly sliding table-fixing and handle
Screw the sliding table fixation A visible with the included M12 nut, as in the following image.
The handle L to move the sliding table can be fixed by turning clockwise with the previously in-
serted into the T-slot nut K (see figure below)
12.2.3 Fine adjustment of the sliding table
The sliding table must be set so that the main
table and the surface of the sliding table of the
same height. The aluminum sliding table itself
can be slightly adjusted with the two locking
screws of the sliding table shots in height.
12.2.4 Mounting bracket
Unpack the frame A and the supporting arm B of the
sliding table arm from the packaging and screw them
ready with 2 thumbscrews as the following image .
Then the boom to the aluminum profile of the sliding
table must be secured with two thumbscrews D . The
two lock nuts M20 must be screwed onto the threads
of the support arm . They are used for height adjust-
ment of the boom .
Now hang the support arm into the sliding table
guide and adjust it in height by means of the
locknut system . The boom must be in level with
the main table and the aluminum profile . Once
you have made this setting, fix the lock nuts
( M20 ) accordingly.