HOLZMANN MASCHINEN TAS 89M, Руководство пользователя

Страница: 26 / 41

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Strana 26
UNIVERZÁLNÍ PONORNÁ PILA / MINI PLUNGE SAW TAS 89M
12 OPERATION
12.1 Delivery content
The machine is delivered pre-assembled.
For transport reasons, some parts of the machine can be assembled by the customer.
Check right after receiving the machine, whether all parts according to the parts list are complete
and without damage. Each visible defect and in particular wrong amounts and transport damages
must be clearly noted on the delivery documents, otherwise the goods shall be considered as
taken over and fully accepted under the sole responsibility of the customer.
12.2 Operation instructions
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
Please observe the following operating instructions so that their work
can be performed safely and has the expected success.
N O T I C E
Check before starting work:
• All cables and plugs
• The function of the protective cover (check the spring!)
The sanding:
• Always use the proper, located in perfect condition saw blades.
• If possible we recommend that the cutting depth is set approximately
2 mm deeper than the material thickness. This should help to ensure
you achieve a clean cut.
• Always guide the machine with both hands.
• Do not exert too much pressure to the workpiece.
• Never lay up the saw with open protective cover.
W A R N I N G
LASER RADIATION! Do not stare into the laser!
Laser class 2: P<1mW, λ=650nm
EN 60825