HOLZMANN MASCHINEN KAP305ECO, Руководство пользователя

Страница: 31 / 45

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 31
KAP 305ECO

For that kind of cuts, the sliding mechanism is unlocked by releasing the fixation screw (1) so
that the saw unit can slide forwards or backwards during the cut.

Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.

Mark the cutting line (by laser).

Place workpiece against stop/fence and table and fix with the clamp device.

Move the machine head to its uppermost position and pull the machine head towards you.

Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),

Make the cut (move the machine head downwards) until it has reached the lowest position
and then slowly push the machine head backwards to be able to machine the wide workpiece
over its entire length.

Move the machine head to the uppermost position.
N O T E
Machine head is spring loaded, do not simply release the machine head, instead move
the handle upwards until the uppermost position is reached (rest position).

Release the ON-OFF switch and wait until saw blade comes to stand still.

Remove workpiece
16.3.3 Slot cuts
Set the depth stop for slot cuts so that the desired cutting depth is obtained at the selected
angle.
Make the mitre or sliding cuts as described in the respective chapter with the difference that the
workpiece is not completely cut through.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
W A R N I N G
Danger due to electrical voltage! Handling at the machine with upright power
supply can lead to serious injuries or death. Always disconnect the machine from
the power supply before cleaning, servicing or maintenance work and secure it
against unintentional reconnection!
17.1 Cleaning
N O T E
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
 Therefore, clean the machine after each use and remove any sawdust with a brush, broom or
vacuum cleaner.
17.2 Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!