HOLZMANN MASCHINEN K5 315VF-2000, Руководство пользователя

Страница: 54 / 94

ASSEMBLY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 54
5-fach Kombination / combined 5-operation machine K5 315VF-2000
 Adjust table height handwheel C so that the cutting tool is
positioned at the desired height on the workpiece.
 Lateral travel of the long hole drilling table with the two stop rods D
set.
 Switch on the machine at the start F key at the main switch.
 Long hole drilling table with move control lever E to the left stop.
 Slowly press down on the cutting tool and workpiece up to the
max.
Milling depth (depending on the milling tool) penetrate.
 Slowly swing control lever to the right and proceed to the stop.
 Repeat the process until the desired depth of cut is reached.
14.6 Milling of workpieces
14.6.1 Changing of the milling head
 Switch off the machine.
 Secure the end cap with a 22mm Allen key.
 With an Allen wrench to remove the screw from the spindle 8mm
remove.
 Remove the cutter head and change these by the appropriate.
 Set a distance from the table top from at least 2mm clearance.
 Install the milling tools as low as possible.
 Select match the height of the milling tool, so that it at least 2mm
is above the upper edge of the spindle. Insert the end cap (E).
 Now screw in the allen screw and tighten it firmly on the spindle.
Check immediately after mounting the free run of the mill.
1. Milling hood and mount handwheel as shown in 6.2.1
2. Spindle height as set in 7.3.6
3. Setting the spindle speed as in 7.1.4
NOTES:
- Beware material setback! To minimize the danger of material setback, they put the hold-down
on workpiece max. 2mm one.
- Set protection on the milling workpiece width + max 5mm one.
- Run the workpiece to be slow and constant.
- You never Milling (except for some special cases, but they require the experience of the user)
to the direction of rotation of the milling cutter.
E
C
D
B