HOLZMANN MASCHINEN K5 315VF-2000, Руководство пользователя

Страница: 49 / 94

ASSEMBLY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 49
5-fach Kombination / combined 5-operation machine K5 315VF-2000
13.5.1 Cutting boards
When performing this operation, the following
equipment shall be used for safe working:

The table extension

the miter fence with support for the workpiece

the guard of the saw blade

the riving knife

the hold-down

the insert in the table
14 OPERATION
14.1 Operating Notes
In some cases, it is the cutting of the laminated plates are required, before use, the
scoring saw blade, to avoid interruption of the cutting edges to the main circular saw
blade.

Set the protective cover of the circular saw blade .

Run the workpiece evenly without flare-ups and without take it back to the end of cutting to .

Set the circular saw blade so high that the ring gear is really reliably covered by the protective
cover (distance between the protective cover and the workpiece - . 5 mm max .

Perform the adjustment of the saw blade height and tilt by only with the machine switched off.

Work only with a well cut tools

Use the push rod at the end of cutting when the distance between the circular saw blade and
the parallel ruler is less than 120 mm.

Make sure that the machine is working without vibrations.

Cracked and deformed circular saw blades can not be repaired. You must be immediately
discarded as scrap and are replaced by ordinary.

For repair and maintenance of circular saw blades with soldered louvers (eg soldering new
cutting blades) the construction of the circular saw blades (tooth shape, tooth width) must not
be changed. The circular saw blades with soldered louvers can be grinding up to minimum
dimensions of the lamella of 1 mm.
Then the circular saw blade must be removed from service.

Select the number of teeth of the circular saw blade such that at least 2-3 teeth working
simultaneously). If only one tooth works, a poor work surface reveals the danger the vibration
and noise exposure increases before setback, increase
14.2 Operation
Switch for operating sawing / spindle shaper /planing
The switch of the B mode, sawing, planing, and the two directions
of rotation for milling can be set.
14.2.1 Engine Start / Stopp
If you want to press the on / off switch A , the EMERGENCY STOP
switch C must be in the open state.
Set to turn on the selected mode with the selector switch B. Press the ˝
I˝ button to start the
engine. To stop the machine, press the ˝ O˝ key
B
Abb. 20
C
A