HOLZMANN MASCHINEN K5 315VF-2000, Руководство пользователя

Страница: 41 / 94

ASSEMBLY
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 41
5-fach Kombination / combined 5-operation machine K5 315VF-2000
13.1.4 Preparation of the surface
Eliminate the preservative, which is applied for corrosion protection of the parts without painting. This
can be done with the usual solvents. Here no nitro solvent or similar means, and in no case use
water.
N O T E
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result in
damage to the surface!
Therefore:

When cleaning, use only mild detergent
13.2 Assembly of parts removed for transport
The combined 5 operation machine is supplied pre-assembled. Sliding table, table guide boom,
outrigger table, rip fence, miter gauge and cutter block guard and saw blade guard must be fit-
ted.
13.2.1 Assembly of individual farming units / parts

Set outside the sliding table to the position on the machine body approx 550mm left side.

Smooth out the flatness of sliding table and the machine table by adjusting the mounting
screws. After leveling with Tighten the lock nut.
Mounting of the slide table
W A R N I N G
The forks of the forklift must be at least 1200 mm long.
Check to see if the eyes are well attached to the body of the machine.
The lifting and transportation of the machine must be performed by quali-
fied personnel with the appropriate equipment.