HOLZMANN MASCHINEN HUB 25T, Руководство пользователя

Страница: 16 / 29

ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 16
HUB 25T | HUB 25T E
CO
15 ASSEMBLY
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
15.1 Tiller Arm Assembling
 Insert the tiller arm(1) into the pump piston, then use a hammer to insert the axle with hole
into the hydraulic pump and tiller arm from the right to the left
 Set the control lever of the handle to the ‘LOWER ‘position, then pass the adjusting nut,
adjusting bolt through the hole of the axle with your hand
 Press the tiller arm down and take away the pin
 Set the control lever of the handle to 'RAISE' position, then raise the lever plate with the pin
(2) and insert the adjusting bolt into the front slot of lever plate.
Note: Keep the adjusting nut under the lever plate
 Use a hammer to insert the 2 dowel pin (4) into the 2 hole of the axle. The draw-bar is now
assembled to the pump.
15.2 Adjusting the Control Lever
The control lever, which can be adjusted in three positions, is located on the hand drawbar of the
lift truck:
 Lifting: handle downwards
 Lowering: handle upwards
 Driving: handle in middle position (neutral position)
If necessary, you can adjust the control lever according to the following steps:
a. If the fork lifts while pumping in the neutral-position, turn the adjusting nut on the
adjusting screw clockwise until the fork does not lift during pumping and the neutral
position functions properly.
b. If the fork sinks while pumping in the neutral-position, turn the adjusting nut
counterclockwise until the fork no longer sinks when pumping.
c. If the fork does not descend when the control lever is in the lowering position, turn the
adjusting nut clockwise until the lifting of the control lever lowers the fork. Then check the
neutral position and make sure that the adjusting nut is in the correct position.