HOLZMANN MASCHINEN HOB 410PRO, Руководство пользователя

Страница: 39 / 65

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 39
HOB 410PRO
14.4 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
N O T I C E
The usage of certain solutions containing ingredients damaging metal surfaces as well
as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.5 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble Possible cause Solution
Machine does not start
or shuts down during
idle

Power supply outage

Damaged or incorrect connected
extension cable

Damaged switch or motor

Check fuse of the power supply

Check plug or extension cable

Contact customer support
Machine stops during
operation

Blunt blade

Feeding speed to high

Motor protection triggered

Check blade

Work with lower feeding speed

Let the motor cool down
Machine vibrates during
operation

Wrong adjusted blade

Ground not flat or base feet wrong
adjusted

Check the setting of the blades

Set the base feet correct
Workpiece clamps
during
thicknessing

Cutting depth to high

Dirty thicknessing table

Set the correct cutting depth and
operate in more steps

Clean and apply the table surface
with lubricant
Bad surface condition
after operating

Blunt blade

Uneven feed of the workpiece

Check blade

Feed workpiece evenly and with
constant pressure
Rough surface after
operating

Workpiece too moist

Use drier workpiece
Cracked surface after
operating

Workpiece was processed against
the direction of growth

Cutting depth to high

Proceed the workpiece in opposite
direction

Set the correct cutting depth and
operate in more steps
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.