HOLZMANN MASCHINEN HOB 410PRO, Руководство пользователя

Страница: 36 / 65

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 36
HOB 410PRO
13.6 Working with the mortising unit (optional)
 Remove the cover (A) form the chuck of the planer
shaft.
 Clamp the required milling tool in the chuck.
 Lay up the workpiece on the mortising table.
 Tilt the downholder (B) to the middle of the
workpiece.
 Pull down the lever of the downholder to clamp the
workpiece.
 Adjust the table height with the hand wheel (C) to
the requested height of the milling tool.
 Adjust the horizontal travel range of the table with
the setting rings (D).
 To start the machine push start button (I).
 Move the table horizontally with the lever (E).
 After the working process stop the machine by
pushing the stop button (G).
 Before further activities wait until blade shaft is at a
standstill!
13.7 After working process
H I N W E I S
After the working process the machine must be turned off:
 Push stop button at the switch unit.
 Disconnect the plug from the switch unit so the machine is disconnected from the
power supply.
 Adjust the blade so that the planer shaft is completely covered.
A
D