HOLZMANN MASCHINEN HOB 410PRO, Руководство пользователя

Страница: 35 / 65

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 35
HOB 410PRO
13.5.2 Thicknessing of workpieces
 Unlock the table lever (B) and set the required height of the
thicknessing table with the hand wheel (A).
 The height will be shown on the scale (C).
 Set the thicknessing table height to the workpiece height
minus the requested cutting depth.
 Maximum cutting depth: 5 mm!
 Fix the thicknessing table height with the lever (B).
 To start the feed, set the feeding lever (D) to the upper
position.
 To start the machine, push the start button (I).
 Insert workpiece so that the surface to be machined
facing upwards and push forward.
 The workpiece is pulled through of the automatic feed.
 As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and
take on the finished workpiece.
A T T E N T I O N
Long workpieces must be supported.
Property damage and injury by bouncing up the workpiece or tilting of
the machine possible!
N O T I C E
 If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
 After operation, switch off the machine with the stop button and set the
feed lever to the lower position.
 Before further activities wait until blade shaft is at a standstill!
 In order for planing, the before described thicknessing procedure must be
reversed.
A
B
C
D