HOLZMANN MASCHINEN HOB 260NL, Руководство пользователя

Страница: 52 / 129

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 52
HOB 260NL
16 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble Possible cause Solution
Machine does not start or
shuts down automatically
during idling

Power supply outage

Damaged or incorrect
connected extension cable

Damaged switch or motor

Check fuse of the power
supply

Check plug or extension cable

Contact customer support
Machine stops during
operation

Blunt blade

Feeding speed to high

Motor protection triggered

Check blade

Work with lower feeding
speed

Let the motor cool down
Machine vibrates during
operation

Wrong adjusted blade

Ground not flat or base feet
wrong adjusted

Check the setting of the
blades

Set the base feet correct
Workpiece clamps during
thicknessing

Cutting depth to high

Dirty thicknessing table

Set the correct cutting depth
and operate in more steps

Clean and apply the table
surface with lubricant
Bad surface condition after
operating

Blunt blade

Uneven feed of the workpiece

Check blade

Feed workpiece evenly and
with constant pressure
Rough surface after operating

Workpiece too moist

Use drier workpiece
Cracked surface after
operating

Workpiece was processed
against the direction of growth

Cutting depth to high

Proceed the workpiece in
opposite direction

Set the correct cutting depth
and operate in more steps
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.