HOLZMANN MASCHINEN HOB 260ECO, Руководство пользователя

Страница: 41 / 111

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 41
HOB 260ECO(LL)
13.7 Working with the mortising unit (optional)
 Clamp the milling tool required for chuck (A) of the planer
shaft
 lay up the workpiece on the mortising table
 Tilt the downholder (B) to the middle of the workpiece
 Pull down the lever of the downholder to clamp the
workpiece
 Adjust the table height with the hand wheel (C) to the
requested height of the milling tool
 Adjust the horizontal travel of the table with both set
bars (D)
 To start the machine push start button (F)
 Move the table with the lever (E) in left direction to the
limiter
 Press down the workpiece carefully on the milling tool and
up to max. penetration depth of milling (depending on the
milling tool)
 Move the lever (E) carefully to the right direction to the
limiter
 Repeat this process until the requested cutting depth has
been reached
 Move the lever backwards to release the milling tool out of
the workpiece
 After the working process stop the machine by pushing the
stop button (G)
 Before further activities wait until blade shaft is at a
standstill!
13.8 After working process
H I N W E I S
After the working process the machine must be turned off:
 push stop button (A) at the switch unit
 disconnect the plug from the switch unit so the machine is disconnected from the
power supply
 adjust the blade so that the planer shaft is completely covered