HOLZMANN MASCHINEN HMS 1000, Руководство пользователя

Страница: 28 / 59

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 28
HMS 700 / HMS 1000
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
NOTICE
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1 Maintenance plan
After each workshift:
 Apply a thin layer of oil on all moveable parts
 Remove grinding cuttings and metal chips from the device
15.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
NOTICE
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface! Clean the machine surface with a wet cloth soaked in a mild solution
15.3 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
16 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble Possible cause Solution
Machine stops or will not start

ON/OFF-switch damaged

Saw unplugged

Overload tripped

Fuse blown or circuit breaker
tripped

Cord damaged

Check the switch

Check all power connections

Allow motor to cool and reset
by pushing off switch

Change fuse or reset circuit
breake

Change cable
Machine slows down during
working

Exerting too much pressure to
the sanding abrasive

Exert less pressure on the
work piece
Bad grinding results

Abrasive too coarse-grained

Use less coarsed abrasive
Grinding angle is wrong

Adjusted angle is wrong

Readjust the angle
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
NOTICE
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.