HOLZMANN MASCHINEN BT46ECO, Руководство пользователя, Страница: 25 / 114

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 25
BT46ECO
Miter gauge
 Tighten the fixing screw using the
Allen key.
 Push the angle stop (6) into the
guide groove (16) of the worktable
(5) (fig.c).
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection
for damage and if tightened properly. Replace any damaged parts before operating the device.
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
Please observe the following operating instructions so that their work
can be performed safely and has the expected success.
N O T I C E
Check before starting work:
 All cables and plugs
 Table and safety fence on tight fit
 The free and centered run of sanding belt and disc
The sanding:
 Always use the proper, located in perfect condition abrasives. (Change
wear of abrasives immediately!) With abrasive in good condition you
obtain a good grinding result.
 Do not exert too much pressure to the sanding abrasive
 Maximum distance table-sanding disc: 2mm!
 The machine has no clamp opportunity, so it is important, as the
whole area hang up the work piece on the worktable and maintain a
firm grip!