OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
30
BT 46
14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1
Operation instructions
W A R N I N G
Perform all machine settings with the machine being
disconnected from the power supply!
A T T E N T I O N
Please observe the following operating instructions so that their work can
be performed safely and has the expected success.
N O T I C E
Check before starting work:
All cables and plugs
Table and safety fence on tight fit
The free and centered run of sanding belt and disc
The sanding:
Always use the proper, located in perfect condition abrasives. (Change
wear of abrasives immediately!) With abrasive in good condition you obtain
a good grinding result.
Do not exert too much pressure to the sanding abrasive
Maximum distance table-sanding disc: 2mm!
The machine has no clamp opportunity, so it is important, as the whole
area hang up the work piece on the worktable and maintain a firm grip!
14.2
Adjustment
14.2.1
Worktable
To pivot the worktable solve the clamping screw, place the worktable in desired position and
fasten the clamping screw (fig.d). To set exactly 90 °, use a protractor (fig.e).
This procedure is also applicable for vertical alignment of the worktable.
14.2.2
Sanding aggregate
For vertical sanding, solve the screw, place the aggregate in desirded position and fasten the
screw (fig.f).
For vertical sanding with the sanding belt, you can mount the worktable on the aggregate.
Therefor remove security fence, bring sanding aggregate in vertical position and fasten the
working table to the mounting holes of the security fence (fig.g).
