HOLZMANN MASCHINEN BS 210TOP, Руководство пользователя

Страница: 28 / 79

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 28
BS 210TOP / BS 275TOP
13.2 Operation
13.2.1 Control panel
SB1 ON-switch SA1 2-step-switch
SB2 OFF-switch SA2 Coolant switch
SB3 EMERGENCY switch
13.3 Adjusting
13.3.1 Blade tension
The ideal tension of the blade is achieved rotating the hand wheel until it
touches the micro switch, that actuates the operation of the machine is
actuated.
Proper blade tension is 4 to 8 MPa as measured on a blade tension gauge.
13.3.2 Blade guide
 Loosen the ratchet screw (J)
 Hold the handle(K) and slide blade guide block as close as
possible to the material without interfering with cut.
 Tighten the hex socket screw(J)
The blade guide is pre- set for a blade with 0,9 mm thickness
Loosen Allen screw (L), adjusting the set
screw (M), the movable teeth (Q) will far
away or close to the blade.
Make sure that between blade and two side
teeth there is at least 0.1mm of play.
Then re-tighten Allen screw (L).
Make sure that between blade and upper
teeth of the pad this is at least 0.2~0.3 mm
of play; if necessary, loosen the Allen screws
(P) that fasten the block and adjust
accordingly.