Rev. 1.00
4
December 13, 2018
Rev. 1.00
5
December 13, 2018
Gang-Writer8-8 User’s Guide
Gang-Writer8-8 User’s Guide
Micro USB Interface
20PIN (5PIN
×
4ICP)
PHB Connector
START Key
STATUS Indicator
ICP1-RUN
ICP1-OK/FAIL
Figure 2. G-ICPM08040 – Programming Module
START Key
DC/USB Power Interface
Programming Module Slot
Figure 3. G-ICPB00040 – Base Board
1.4 Software Introduction
The software HOPE3000 (V3.26 and above) is used, refer to appendix
HoltekEWriterUsersGuide(125).pdf
for detailed HOPE3000 usage description. After the G-ICPM08040 hardware is connected, the hardware
name and firmware version will be displayed at the lower right corner of the software interface, as shown
in Figure 4:
