1
2
Fig 1
AEMS CORE
Reflex Sight
Model
Important Notices
Features
Thank you for purchasing the
AEMS CORE
Reflex Sight
from HOLOSUN. The
AEMS
CORE
is an advanced enclosed
micro sight with a 2MOA dot reticle housed in a Aluminum
body. It features a motion sensor and battery power.
Before operation, please read the User Manual carefully.
1. Advanced LED technology: Up to 50,000 hours
2. Parallax free with unlimited eye relief
3. 2MOA Dot
4. Shake Awake sensor
5. 10 Daylight & 2 Night Vision compatible brightness
settings
6. Rechargeable internal battery
7. Window Size: 0.87” x 1.1” (inches)
8. Solid 7075 aluminum Body
9.1.63” Center Dot Height (Lower 1/3 Co-witness)
10. Waterproof: IP67
1. Ensure the firearm is unloaded and cleared by removing all
ammunition and magazines from firearm and verifying an
empty chamber before installation or battery
replacement.
DO NOT ATTEMPT TO INSTALL THIS SIGHT KIT
ON A LOADED FIREARM.
2. Please keep the packaging should you need to make a
warranty claim.
Objective Lens
A canted objective lens is part of the design of
reflex/reflective optical sights. In order to create a proper
reflection of the reticle/dot the objective lens must be
perpendicular to the LED. Because the LED is mounted off to
one side, the objective lens will be canted in that direction.
Fig2
Battery
Installation onto Firearm
1.The AEMS CORE is compatible
with any firearm with a Picatinny
mounting rail. If your firearm
does not have a Picatinny rail,
contact a qualified gunsmith.
User Manual
AEMS CORE
your purchase.
2. A high quality battery can power the2MOA dot for up to
50,000 hours at a mid setting.
Caution:
Do not use a rechargeable battery.
3.Battery Replacement(Fig3):
a. Removing the battery :
I. Remove the battery tray screws.
ii. Use the included tool as a lever in the top battery tray slot
to remove the battery tray and battery.
b. Battery installation :
I. Insert the battery into the battery tray with the
POSITIVE
side facing DOWN
.
ii. Insert and press the tray into the battery compartment.
iii. Tighten the battery tray screw.
Caution:
The loss or damage of the seal ring may cause moisture to
enter into the compartment which could damage the
product.
Fig 3
Clamp
screw head
Clamp
Fig 4
2. Using the included T10 Torx tool, loosen the cross bolt and
then attach the sight onto the Picatinny rail in an appropriate
position. Apply forward pressure towards the muzzle and
tighten the clamp screw to 20 inch/lbs using non-permanent
thread lock.(Fig4)
Advanced Enclosed
Micro Sight
AEMS
CORE
-
110101
AEMS
CORE
-
120101
RED Dot
Green Dot
Screw
Battery tray
Seal ring
Battery
Slot
Battery
compartment
1. One high quality CR2032 Lithium battery is included with
