6
IV.
DESCRIPTION OF CONTROL ELEMENTS
4.0
INTERFACE ACCESORIES
4.0.1
Two Pedal Footswitch
A heavy duty waterproof dual footswitch for CUT and COAG modes is
supplied. The mode selectors described in 4.2 determine the cut and coag
modes activated by the respective footswitch. The footswitch indicators
described in 4.2, and will indicated the activated mode. The yellow footswitch
indicator will be ON when the CUT footswitch is depressed. The blue
footswitch indicator will be ON when the COAG footswitch is depressed. The
footswitch indicators are normally OFF until one of the footswitch pedals is
depressed.
The footswitch may be used with any handpiece compatible with the Surgitron
®
Dual/EMC.
4.0.2
Handpieces
A variety of handpieces are available for use with the Surgitron
®
Dual/EMC.
A three-button handpiece adds convenience by enabling the user to control
CUT, BLEND, and COAG modes via fingerswitch. The depressed button will
control output function and disregards the front panel display setting. The
fingerswitch operational features are as follows:
4.0.2.1 CUT button will activate CUT mode. When depressed, the Yellow
Light (CUT) Indicator will be illuminated.
4.0.2.2 BLEND button will activate BLEND mode. When depressed, The
Yellow Light (BLEND) Indicator will be illuminated.
4.0.2.3 HEMO button will activate COAG mode. When depressed, the Blue
Light (COAG) indicator will be illuminated.
4.0.3
IEC-NPD disposable neutral plate
The IEC Neutral plate must be used with the RF Generator during activation.
To use, insert the molded plug of the Neutral Plate into the RF Generator as
shown in Figure 4.2.
4.0.4
Power Cord
The power cord connects the RF Generator to the supply mains.