Cenova Image Analytics Server 3.0 User Guide
Chapter 3: System Operation
Page 24
MAN-05463-001 Revision 002
5.
Click
Shutdown
. The server prompts ‘Are you sure…?’ Click
OK
to switch the
server off.
Note
Physical access to the server is required to restore power from a shutdown. If the server
is in a remote location, use
Restart
.
3.3.2 Starting Up the Server
If the server has been powered off, you can switch it back on by pressing the power
switch on the front of the computer. (An indicator light indicates whether the server is on
or off.) The Cenova software starts up automatically, and the server should be ready for
use within 3–5 minutes.
3.3.3 Restarting the Server
You might need to restart the Cenova server if results are not transferring. Often,
restarting the server clears any errors. In some cases, your service representative will ask
you to restart the server.
`To restart the server:
1.
Using a computer that is on the same network as the Cenova server, open a web
browser.
2.
Type the IP address for the Cenova server in the address box and press
[Enter]
. You
do not need to type ‘http’ or anything other than the IP address.
3.
At the log-in screen, enter the user name (‘Administrator’) and password. The About
screen should appear as shown in the previous procedure.
4.
On the About screen, click
System Control
.
5.
From the System Control screen, click
Restart
. The server prompts ‘Are you sure…?’
Click the Restart button once more. The server should shut down and then restart
automatically. The server should be ready for use within about 5 minutes.
Note
To continue using the server, refresh the browser by repeating steps 1–3.