Holden Acadia Owner Manual (Holden-Localizing-Holden-12561773) - 2019 -
crc - 8/28/18
200
Driving and Operating
Warning (Continued)
Note:
The vehicle's brake system
remains operational, but without
ABS assistance. Have a Holden
Dealer check the system as soon
as possible.
Electric Parking Brake
The Electric Parking Brake (EPB)
switch is located on the centre
console and can always be
activated, even if the ignition is off.
The system has a
Y
Electric
Parking Brake light and a
8
Service
Parking Brake light.
See
and
. Parking
brake-related Driver Information
Centre (DIC) messages may also
display. In case of insufficient
electrical power, the EPB cannot be
applied or released.
Before leaving the vehicle, check for
the
Y
light to ensure that the
parking brake is applied.
EPB Apply
To apply the EPB:
1. Ensure the vehicle is at a
complete stop.
2. Pull the EPB switch
momentarily.
The
Y
light will flash and then stay
on once the EPB is fully applied.
If the
Y
light flashes continuously,
then the EPB is only partially
applied, or there is a problem with
the EPB. A DIC message will
display.
Release the EPB switch and try to
apply it again. If the light does not
come on, or keeps flashing, have
the vehicle serviced.
Do not drive the vehicle if the
Y
light is flashing. See your dealer.
See
If the
8
Service Parking Brake light
or message is on or the
Y
light
flashes when the ignition is turned
on, pull the EPB switch. Continue to
hold the switch until the
Y
light
remains on. If the
8
Service Parking
Brake light or message remains on,
see your dealer.
If the EPB switch is pulled while the
vehicle is moving, the vehicle will
decelerate as long as the switch is
pulled. If the switch is pulled until
the vehicle comes to a stop, the
EPB will remain applied.