HOLDEN Malibu EM 2015, Руководство пользователя

Страница: 69 / 330

Black plate (29,1)
Holden Malibu Owner Manual (GMNA-Localizing-Holden-9272603) - 2015 -
CRC - 11/21/14
Seats and Restraints 3-29
backbone, which is still very weak,
is under less strain in the event of
an accident.
Ensure that the child restraint
system to be installed is compatible
with the vehicle type.
Ensure that the mounting location of
the child restraint system within the
vehicle is correct.
Allow children to enter and exit the
vehicle only on the side facing away
from the traffic.
When the child restraint system is
not in use, secure the seat with a
seat belt or remove it from the
vehicle.
Note: Do not stick anything on the
child restraint systems and do not
cover them with any other materials.
A child restraint system that has
been subjected to stress in an
accident must be replaced.
Infants
Rearward facing infant capsules are
designed so that in the event of a
collision, impact forces will be
evenly spread over the baby's back,
with minimal jarring to the
vulnerable head and neck area.
Young children
Forward facing child seats are for
use when the child is able to sit and
easily hold their head upright.
Booster seats
Booster seats are for when children
outgrow a typical forward facing
child seat, but are still too small for
three point seat belts.
Older children
A child should use a normal three
point seat belt only when:
. They can sit against the back of
the rear seat with knees bent
comfortably at the edge of
the seat.
. The lap belt rests low and snug
across the hips, not across the
stomach.
. The sash belt is centred on the
shoulder and chest.
. They are able to stay seated like
this for the entire trip.
Where to Put the
Restraint
{
Warning
It is safest for children to be
seated in the rear seat.
Only child restraints that have
clips to attach to the vehicle's
anchorage fitting (as shown in the
following illustrations) are to be
used. Earlier types of child
restraints may not attach securely
to this type of anchor.
Use only Standards Australia and
New Zealand approved child
restraints and harnesses. Only
purchase a child restraint which
carries the appropriate Standards
Australia sticker of approval.
(Continued)