TONNEAU COVER FITTING INSTRUCTION
HOLDEN VG VR VS
SINGLE CAB WITHOUT SPORT BAR
1990 – 2001
PART NO: ATB01063
BASIC TOOLS REQUIRED
Drill, 4mm Drill Bits, Rivet Gun, Marking Pencil/ Pen
CONTENTS
-
1 x Tonneau Cover
-
2 x Tonneau Support Bar
-
1x Fitting Instruction
-
4 x Bar Brackets
-
8 x Rivets
1.
INSTALLATION PROCEDURE
NOTE:
Read entire instructions prior to start.
STEP 1
Fit the front of the Tonneau to the front of the Ute tub placing the LTD clips (Fitted on the
Tonneau Cover) on to the LTD posts already fitted on the body.
(Behind rear windscreen).
STEP 2
Fit your tonneau cover support bar/s into position (Refer to the instructions below)
STEP 3
Drape cover over support bars.
STEP 4
Fit Bunji Loops to Body Hooks, starting at the rear then fitting the side’s bunjis.
STEP 5
Your Tonneau Cover is now fitted.
2.
MULTI-FIT SUPPORT BAR
The Aussie Tonneau Multi - Fit Support Bar is designed to fit almost all Utes on the Market, from Suburu
Brumbys to Cab Chassis aluminium trays.
2.1 BASIC TOOL REQUIRED
-
Drill, 4mm drill bit
2.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
