FM-ONE
HOKUTO DENSHI
CO;LTD;
株式会社
18
With the switch on
FM-ONE
【
Offline
】
How to write in using the switch on the FM
－
ONE body. Instead of connecting to the PC, writing in is done with the switch on
the body (Offline operation). As it can operate with batteries, it has a wider advantage, for example, maintenance is possible in
the field or it is used for evaluation at the
client’s office.
B
: Write
switch (OK)
【
Connection
】
To write in, the equipment must be connected as a
diagram describes on the right. If the body is not
connected to PC, power cannot be supplied from the USB
bus. Prepare the attached AC adapter or specified
batteries. To start writing in, the target must also be
supplied with power.
【
advance preparation of a project file
】
To make write in, the project file must be stored in advance in the CF put in the body.
【
Writing procedure
】
①
Connect the FM
－
ONE body with CF inserted in to
the target board, and power should be supplied with
first the body and next the target board.
②
The startup screen on the right (result of self-test) is
shown on the LCD of the FM
－
ONE body for about
three seconds.
③
If self-test is done properly, one of the project files
saved in the CF will be immediately displayed.
FM-ONE System 2.4V
Folder
DEF
Date
05/01/01
Time
00:00:00
When another project is to be selected, display the
desired project by using
↑↓
up-down keys.
Alteration of Parameter of the saved project.
①
Display the project to be altered and push the
SET
button.
②
Alter the items by pushing
↑↓
keys, and select the desired item
from among items by pushing
→
←
keys, and alter the set value by
the
↑↓
keys.
③
Determine the content by pushing
Write/OK button, and then reset
form the altered screen. (Access display lights once.)
If Cancel button is pushed instead of Write/OK, the set value is not
altered and resets.
④
Start writing by pushing
Write
button.
⑤
Completion of writing is displayed as follows:
Programming is continued by push the Write
button. In ending programming, please push the
Write button after cancel button or N is selected.
FM-ONE System 2.4V
user1
sum=00000000
user2
sum=00000000
Complete
【
The follow of programming
】
※
Screen display when AC adapter is used.
The programming after the second by off-line
changed as shown in left figure.
Because the small file is taken into the memory at
the programming,
Verify and
Retry become
high-speed.
From
CF to on-chip
FlashROM
Target board
Flash
on-chip microcomputer
FM-ONE
Attached AC adapter
or batteries
Offline operation
Starting System
・ ・ ・
Self
test
OK
version xxxxxxxx
Upon start-up, the results of self-test is displayed.
Write
Ok
SET
State of access is displayed
Cancel
FM-ONE SYSTEM
USB/DC
Folder
DEFAULT
Date
08/07/31
Time
16:00:00
FM-ONE SYSTEM
USB/DC
[Exec DEFAULT.HDP ]
YES NO
FM-ONE SYSTEM
[Exec DEFAULT.HDP ]
Starting boot mode.
Please wait
・・・・・・
FM-ONE SYSTEM
USB/DC
(Programming omission)
[Exec DEFAULT.HDP ]
user1 sum = xxxxxxxx
user2 sum = xxxxxxxx
complete. Again? Y / N
①
②
③
④
⑤
Key operation (Write)
Key operation
(Cancel)
Key operation (Write)
Key
operation
(Write)
Key operation (Cancel)
former flow