FM-ONE
HOKUTO DENSHI
CO;LTD;
株式会社
10
With
FM-ONE Project File Maker
【
Online
】
The operation of the FM-ONE Project File Maker is described.
Connection to the FM-ONE body or the target board is not always necessary.
Connect the system when necessary as the diagram right shows.
Prepare the user program in the MOT/HEX file format,
and then start the installed FM-ONE Project File Maker.
Refer to the following start-up direction:
Diagram to start-up
To confirm
version information, click on the HELP tab.
Details screen displayed
MOT/HEX
P
P
C
C
Project File Maker
Online operation
USB
cable
From
PC to CF
Target board
Flash
on-chip microcomputer
FM-ONE
From
CF to on-chip
FlashROM
Display a detailed setup diagram.
Operation screen starts with a compact
screen hiding a detailed setup. To produce
a project file, click on the Details key.
Double-click on the
Icon of
FM-ONE
Project File Make
ｒ
.
User program (Select by MOT or HDU)
User program for Secondary area (Select by MOT or HDU)
Writing Control Program corresponding to MCU
【
Automatic selection is possible by MCU Type name
】
Writing Control Program for Secondary Area
【
Automatic selection is
possible by MCU Type name
】
screen display button
of file selection
MCU
Selection of type name
Clock mode,
frequency, multiplication
factor
【
Turn on when necessary
】
Pin setup aiming at an automatic control to a
boot mode
Transmission
rate
asynchronous
clock synchronizer
Error message display
Language alteration
Japanese or English can be
selected.
*
Some descriptions are
written only in Japanese.
To hide the detailed setup
screen, click on the Details
key again.
Connected to the body.
Establishment of
connection
OK
The tab which hid can be displayed.