Hog Technologies Stripe Hog SH8000, Руководство по эксплуатации

Страница: 97 / 192

97
Section 4:
Lubrication & General Maintenance
4.1 Lubrication & General
Maintenance Introduction
Lubrication Points
You should become familiar with the location of all
components that require frequent lubrication and
include them in the general maintenance schedule.
Some of these lubrication points require special-
ized lubricants. The lubrication points shown in
the photos and listed in the Lubrication Charts
on the following pages in this section provide a
guide to the location of the lubrication points on
your machine.
NOTICE:
IT IS NOT POSSIBLE TO SHOW ALL vALvES, HINGES,
LATCHES AND SAFETY PINS ON THE LuBRICATION CHARTS.
RELATED ITEMS NOT SHOWN SHOuLD ALSO BE INCLuDED
IN YOuR MAINTENANCE ROuTINE.
Refer to the Maintenance Matrix chart in the
Scheduled Maintenance section in this manual
and component manufacturer’s operating and/or
maintenance manuals for lubricant specifications
and maintenance schedules.
Some lubrication points require grease daily or
weekly. In extremely wet or dirty conditions the
requirements could increase. The lubrication fre-
quency outlined in this section should be consid-
ered the minimum requirement.
Before operating or performing any maintenance
on the vehicle make sure the machine is properly
shutdown and secured in the service position.
General Maintenance
Some components of the ultra high pressure
water and vacuum systems require daily main-
tenance or may require maintenance during a
typical waterblasting shift. This maintenance is
considered routine general maintenance and a
component of the waterblasting process. The
service procedures for these items are described
in this section of the manual. The frequency for
maintaining general maintenance items will vary,
depending on the quality of the clean water supply,
the overall condition of the waterblasting systems
and proficiency of the operators.
CAUTION
THE GENERAL MAINTENANCE PROCEDuRES OuTLINED
IN THIS SECTION MuST BE FOLLOWED EXACTLY TO
AvOID DAMAGING COMPONENTS AND/OR vOIDING THE
WARRANTY.
Scheduled Maintenance
Components that are typically serviced periodi-
cally or at specific hours of operation are consid -
ered scheduled maintenance items. The service
procedures for those items are described in the
Scheduled Maintenance section of the this manual.
Service Position
Properly shutting down and securing the machine
for service is critical to the safety of the operator
and/or service personnel.
Use the following procedure to place the
machine in the service position:
1. Make sure all components lifted hydraulically
are in the full down position or properly sup-
ported to remove the load from the cylinders
and hinges.
2. Shift the truck to Drive Mode before shut-
down to prevent accidental activation of
waterblasting systems.
3. Park vehicle on a level area and block wheels.
4. Apply parking brake.
5. Shutdown the engine and disable the truck
electrical system at the battery switch or main
circuit breaker.
6. Follow all Lockout/tagout and additional shut-
down procedures established in your company
safety guidelines to complete the service
position.
WARNING
SEvERE INJuRY TO PERSONNEL OR DAMAGE TO
EquIPMENT CAN RESuLT IF THE vEHICLE ROLLS OR IS
STARTED uNEXPECTEDLY DuRING SERvICE. ALWAYS
FOLLOW THE RECOMMENDED PROCEDuRES TO PLACE
THE uNIT IN THE SERvICE POSITION AND APPLY LOCKOuT/
TAGOuT PROCEDuRES BEFORE ALLOWING ANYONE TO
SERvICE COMPONENTS.