Hoffmann PP2-NCF, Руководство по эксплуатации и техническому обслуживанию

Страница: 42 / 75

Operating and Maintenance Manual
42
©
HOFFMANN PP2-NCF
• Version 7.267 • 12-2017
19 Trouble Shooting Chart
Error # Indication Reason Remedy
1 Router motors will not start Motors have not been switched on
No power to motors
Check switches on motors
Check power cords for internal
damage.
Check for proper connection
2 R
outer speed (rpm’s) decrease
Dull tooling
Feed rate to high
Check and replace tooling
(router bits)
Adjust feed rates with flow control
valves on main cylinder
3 Loud noise during machining
cycle. Dull or damaged tooling.
Check and replace tooling
(router bits)
4
Router won’t move freely.
Guides and/or tracks dirty. Clean tracks and guide rods.
5 Keyway location offset from left to
right hand work piece Router reference points not adjusted
properly Adjust reference points in
touchscreen menu
6 Dovetail Key too tight when
inserted
– wood splitting
Router bits cut too deep into miter face Move motor(s) back by 0.2- 0.5mm
7 Dovetail Key not tight enough
when inserted
– miter faces do
not touch
Router bits do not cut deep enough into
miter face Move motor(s) forward by 0.2-
0.5mm